MacDon A40-D Pull-Type - Manual (Page 52)

SECTION 6 OPERATION
169000
50
Revision F
6.6.2 Reverser Valve Jumper Hose
An optional reverser valve block (A) to reverse
the header drive in the event of plugging may
have been installed on M150, M155, and M200
windrowers. A jumper hose on this valve block
has a specific routing for each model of auger
header. Check routing of the jumper hose as
follows, and change as required:
a. Move LH windrower platform to open position to
expose hydraulic valve blocks.
IMPORTANT
Do NOT operate the header unless hose
is routed as shown.
HOSE (B) POSITION - A40-D
M200 SHOWN - M150, M155 SIMILAR
B
A