MacDon A40-D Pull-Type - Manual (Page 51)

SECTION 6 OPERATION
169000
49
Revision F
e. Route bundle (E) from windrower through
support (F) and access hole (G) in header frame
alongside existing hose bundle (H) from header.
f. Remove cover on header electrical
receptacle (J).
g. Push connector onto receptacle, and turn collar
on connector to lock it in place.
h. Attach cover to mating cover on windrower
wiring harness.
i. Remove caps from hydraulic couplers, and
clean if necessary.
j. Push hose connectors onto mating receptacles
(as shown) until collars on receptacles snap into
lock position.
k. Route auger return and reel pressure hose
bundle (H) from header to windrower, and locate
bundle above existing hose support (K)
(as shown).
l. Secure with three straps (L), and lower lever (D).
m. Push auger/reel pressure (A) and auger/reel
return (B) hose couplers onto mating
receptacles on valve block until collar on
receptacle snaps into lock position.
n. Re-route header drive hoses. Refer to Section
6.6.1.1 M100, M105 step q. on page 41.
G
H
J
E F
STANDARD HEADER
KNIFE and
CONDITIONER
PRESSURE
CASE DRAIN
KNIFE and
CONDITIONER
RETURN
REEL and AUGER
PRESSURE
GRASS SEED HEADER
KNIFE PRESSURE
(FEMALE FITTING
AT HEADER)
KNIFE RETURN
(MALE FITTING
AT HEADER)
CASE DRAIN
AUGER and REEL
PRESSURE
H
K L
D
B
A