MacDon A40-D Pull-Type - Manual (Page 170)

SECTION 7 MAINTENANCE AND SERVICING
169000
168
Revision F
7.18.2.3 Maintenance Record: Pull-Type
Pull-Type Mower Conditoner
ACTION:  - Check  - Lubricate  - Change
MA
IN
TEN
ANC
E
RE
CO
RD
Hour Meter Reading
Date
Serviced By
FIRST USE Refer To Section 7.18.2.1 Break-In Inspection: Pull-Type
100 HOURS OR ANNUALLY

Hydraulic Oil Filter - First 100 H Only

Conditioner Drive Gearbox Lube Level

Wheel Bolt Torque

Wheel Hub Bearings

Knife Drive Box Bolt Torque

Knife Drive Box Lubricant Level
END OF SEASON Refer To Section 6.19 STORAGE
10 HOURS OR DAILY
NOTE: A RECORD OF DAILY MAINTENANCE IS NOT NORMALLY
REQUIRED BUT IS AT THE OWNER/OPERATOR’S DISCRETION.

Auger Drive Chain

Hydraulic Hoses and Lines

Hydraulic Oil Level

Reel Drive Chain

Sections, Guards and Hold-Downs

Knife Assembly
 Knife Drive Box Bolt Torque
- First 10 H Only
25 HOURS

Knife Head
50 HOURS

Auger Drive and Jackshaft Bearings.

Frame-to-Header Pivot

Gauge Roller Bearings

Lower Float Link Bushings

Main Driveshaft Bearings

Reel Shaft Bearings

Conditioner Gearbox Oil - First 50 H Only

Conditioner Drivelines

Roll Pivots

Knife Drive Cross-Shaft

Spring Pivots

Tire Pressure

Articulating Power Tongue (APT) Pivot

Knife Drive Box Oil - First 50 H Only
250 HOURS

Hydraulic Oil Filter
500 HOURS OR 3 YEARS

Hydraulic Oil
1000 HOURS OR 3 YEARS

Conditioner Drive Gearbox Lubricant

Knife Drive Box Lubricant