MacDon A40-D Pull-Type - Manual (Page 17)

SECTION 2 SAFETY
169000
15
Revision F
2.3.4 Safety Sign Interpretations
In the safety explanations below, (a) refers to
the top or left position panel, (b) refers to the
bottom or right position of the safety decal
depending on decal orientation.
NOTE
If there are more than two panels in a
decal, the lettering will continue
downward, or to the right, depending on
decal orientation.
1. MD #36651
a. Rotating driveline
b. DANGER
• Stop engine and remove key before
opening shield.
• Do not operate if guard is missing or
shields not in place.
• Failure to comply will result in death or
serious injury.
2. MD #113482
a. General hazard pertaining to machine
operation and servicing.
b. CAUTION
To avoid injury or death from improper or unsafe
machine operation:
• Read the operator’s manual, and follow
all safety instructions. If you do not have
a manual, obtain one from your dealer.
• Do not allow untrained persons to
operate the machine.
• Review safety instructions with all
operators annually.
• Ensure that all safety signs are installed
and legible.
• Make certain everyone is clear of
machine before starting engine, and
during operation.
• Keep riders off the machine.
• Keep all shields in place, and stay clear
of moving parts.
•
Disengage header drive, put
transmission in neutral, and wait for all
movement to stop before leaving
operator’s position.
• Shut off engine and remove key from
ignition before servicing, adjusting,
lubricating, cleaning, or
unplugging machine.
• Engage locks to prevent lowering of
header, or reel before servicing in the
raised position.
• Use slow moving vehicle emblem, and
flashing warning lights when operating
on roadways unless prohibited by law.
(continued next page)