MacDon A40-D Pull-Type - Manual (Page 49)

SECTION 6 OPERATION
169000
47
Revision F
j. Push hose connectors onto mating receptacles
(as shown) until collars on receptacles snap into
lock position.
k. Route auger return and reel pressure hose
bundle (H) from header to windrower, and locate
bundle above existing hose support (K)
(as shown).
l. Secure with three straps (L), and lower lever (D).
m. If valve blocks are NOT configured as shown
above, install required fittings as described in
A40-D Auger Self-Propelled Windrower Header
Unloading and Assembly Instructions - MD
Part #169078 that was supplied with your
A40-D header.
n. Push auger pressure (A) and auger/reel
return (B) hose couplers onto mating
receptacles on valve block until collar on
receptacle snaps into lock position.
o. Proceed to Section 6.6.2 Reverser Valve
Jumper Hose.
M200 - WITHOUT REVERSER VALVE
A
B
AUGER
PRESSURE
AUGER/REEL RETURN
M200 - WITH REVERSER VALVE
A
B
AUGER
PRESSURE
AUGER/REEL RETURN
A B
H
K L
D
STANDARD HEADER
KNIFE and
CONDITIONER
PRESSURE
CASE DRAIN
KNIFE and
CONDITIONER
RETURN
REEL and AUGER
PRESSURE
GRASS SEED HEADER
KNIFE PRESSURE
(FEMALE FITTING
AT HEADER)
KNIFE RETURN
(MALE FITTING
AT HEADER)
CASE DRAIN
AUGER and REEL
PRESSURE