Regency Energy E18 Small Gas Insert - Manual (Page 38)

38
Regency ® E18 Gas Fireplace Insert
INSTALLATION
INSTALLATION OF THE E18 INTO EXISTING UNITS
$GDSWRU3ODWH*DVNHW V
9HQW6OLGH3ODWH
6OLGH3ODWH5HWDLQHU
$GDSWRU3ODWH
6KHHW0HWDO
6FUHZV
6KHHW0HWDO
6FUHZV IURP
9HQW6OLGH
3ODWH
Diagram 10.1
Diagram 10.2
STEP #1: VENT CONNECTION TYPE A
1. Attach the Flex Vent Section to the Adaptor Plate using a
Ring Clamp and/or 3 self drilling sheet metal screws.
2. Using 4 Sheet Metal Screws, attach the Adaptor Plate,
Vent Section and Adaptor Plate Gasket to the top of the
existing Fire Box.
See specifi c instructions to your installation to determine what
position the Adaptor Plate should be located.
3. Attach the Slide Plate Retainer to the Vent Slide Plate using the
setting outlined in your unit specifi c installation guide.
4. Using the a ring clamp and/or 3 self drilling sheet metal screws,
attach the Vent Slide Plate to the Flex Vent Section
STEP #1: VENT CONNECTION TYPE B
1. Remove the 6x #8 sheet metalscrews from the top of the Vent
Slide
Plate.
2. Locate the Adaptor Plate on the top of the Slide Plate
Retainer and attach with 4 x #8 screws removed in the
previous
step.
3. Place the Adaptor Plate Gasket on the top of the
Vent Slide Plate
4. Using 4x sheet metal screws, locate and fasten the Vent
Slide Plate assembly to the fi rebox top of the existing fi rebox.
Two (2) screws go through the Vent Slide Plate and Adaptor
Plate, two (2) screws go through the Adaptor Plate only.
THE APPLIANCE MUST
NOT BE CONNECTED TO A
CHIMNEY FLUE SERVING
A SEPARATE SOLID FUEL
BURNING APPLIANCE.
Adaptor Plate Gasket
Adaptor Plate
Sheet Metal
Screws
Flex Vent Section
Vent Slide Plate
Slide Plate Retainer