Regency Energy E18 Small Gas Insert - Manual (Page 60)

60
Regency ® E18 Gas Fireplace Insert
MAINTENANCE
WIRING DIAGRAMS
CAUTION: Label all wires prior
to disconnection when servicing
controls. Wiring errors can
cause improper and dangerous
operation.
WARNING: Electrical Grounding Instructions
This appliance is equipped with a three pronged
(grounding) plug for your protection against shock
hazard and should be plugged directly into a prop-
erly grounded three-prong receptacle. Do not cut
or remove the grounding prong from this plug.
This heater requires a 120V A.C. supply for
operation of the circulation fan which is required
for operation of the fi replace. In case of a power
failure, the fi replace can be turned on but a
thermal safety switch will cut out the appliance
before it gets to hot. The unitl will cycle on
and off as required to stay within temperature
specifi cations. Caution: Ensure that the wires do
not touch any hot surfaces and are
away from sharp edges.
When connected with 120 volts, the appliance
must be electrically grounded in accordance
with local codes or, in the absence of local
codes the current CSA C22.1 (in Canada) or
with the National Electrical Code ANSI/NFPA
70-1987 (in USA).
NOTE: This unit is equipped with a heat
sensor thermodisc which will
prevent the blower from operating
until the unit reaches the correct
temperature.
For NATURAL GAS Units and Units NOT Equipped with DC Spark Boxes
WHITE
WHITE
GREEN
BLACK
ROTARY SPEED CONTROL
THERMODISC
RED BLACK
BLACK
BLACK
HI LIMIT
SWITCH
SPILL
SWITCH
2 WAY
SWITCH
Diagram 19.1
Diagram 19.2