Rockwell Automation 22-SCM-232 Serial Converter Module - Manual (Page 17)

Installing the Serial Converter Module 2-3
1. Disconnect the 22-RJ45CBL-C20 cable from the DSI-enabled drive
and then from the converter module. To disconnect the cable, press
on the cable latch and then pull it out.
2. Disconnect the 1203-SFC serial cable from the serial converter
module and then the computer.
Removing the Serial Converter Module
!
ATTENTION: Risk of injury or equipment damage exists. If the serial
converter module is transmitting control I/O to the drive (indicated by a
solid green diamond LED), the drive may fault when you remove or
reset the serial converter. Determine how your drive will respond before
removing or resetting a connected serial converter module.