Rockwell Automation 22-SCM-232 Serial Converter Module - Manual (Page 27)

Configuring the Serial Converter Module 3-9
Change to settings on some module parameters require that you reset the
serial converter module before the new settings take effect. You can reset
the module by cycling power to the module or by using Parameter 05 -
[Reset Module].
To reset the serial converter
• Set Parameter 05 - [Reset Module] to either Reset Module or Set
Defaults. “Reset Module” will reset the serial converter. “Set
Defaults” will set all parameters in the serial converter to their
factory-default values.
Figure 3.10 Reset Module Parameter in HyperTerminal
After you enter the “Reset Module” value, the serial converter will be
reset. This parameter will then be reset to “Ready.”
Resetting the Serial Converter Module
!
ATTENTION: Risk of injury or equipment damage exists. If the serial
converter module is transmitting control I/O to the drive (indicated by a
solid green diamond LED), the drive may fault when you remove or
reset the module. Determine how your drive will respond before
removing or resetting a connected serial converter module.
Press the UP ARROW or DOWN ARROW key to scroll
through the parameter list. Press the LEFT ARROW
or RIGHT ARROW key to modify parameter values.
Press the ENTER key to save a new value.
5> Reset Module = Reset Module