Rockwell Automation 1771-OFE/B Analog Output Module User Manual - Manual (Page 15)

Chapter
2
Publication 1771Ć6.5.30 - November 1998
Module Installation
In this chapter, you will read about:
For information on See page
Compliance to European Union Objectives . . . . . . . . . . . . . . 2-1
Calculate the Power Requirements . . . . . . . . . . . . . . . . . . . . 2-2
Set Module Configuration Jumpers . . . . . . . . . . . . . . . . . . . . 2-3
Key the Backplane Connectors . . . . . . . . . . . . . . . . . . . . . . . 2-7
Install the module and Field Wiring Arm . . . . . . . . . . . . . . . . 2-8
Connect the Wiring . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-10
Ground the Chassis and Module . . . . . . . . . . . . . . . . . . . . . . 2-11
Read this installation chapter completely before you install your
module. Double check all connections and option selections before
you begin programming your module.
!
ATTENTION: To avoid injury to personnel and
damage to equipment, disconnect and lockout all ac
power supplies before installing and wiring the output
module.
If this product has the CE mark, it is approved for installation within
the European Union and EEA regions. It has been designed and
tested to meet the following directives.
EMC Directive
This product is tested to meet Council Directive 89/336/EEC
Electromagnetic Compatibility (EMC) and the following standards,
in whole or in part, documented in a technical construction file:
•
EN 50081-2EMC – Generic Emission Standard, Part 2 –
Industrial Environment
•
EN 50082-2EMC – Generic Immunity Standard, Part 2 –
Industrial Environment
This product is intended for use in an industrial environment.
Low Voltage Directive
This product is tested to meet Council Directive 73/23/EEC
Low Voltage, by applying the safety requirements of EN 61131–2
Programmable Controllers, Part 2 – Equipment Requirements and
Tests.
What This Chapter
Contains
Compliance to
European Union Directives