Rockwell Automation 1771-OFE/B Analog Output Module User Manual - Manual (Page 63)

6-11
Publication 1771Ć6.5.30 - November 1998
Table 6.D
Resistor Potentiometers
Channel Resistor Potentiometer
1 R66
2 R73
3 R80
4 R87
11. Remove the extender card and circuit board from chassis.
12.Replace Last State configuration jumpers to their original
position.
13.Replace the module covers and insert the module into the I/O
chassis.
14.Replace field wiring on field wiring arm (or position original
wiring arm on module if you used a spare field wiring arm for
this calibration procedure).
Your module is now properly calibrated and ready for use.
In this chapter, you learned how to calibrate your module using
simple test equipment.
Chapter Summary