Rockwell Automation 1788-EN2PAR EtherNet/IP and ControlNet to PROFIBUS PA Linking Device User Manual - Manual (Page 12)

12 Rockwell Automation Publication 1788-UM058B-EN-P - September 2014
Preface
European Hazardous Location Approval
The following applies when the product bears the marking.
This equipment is intended for use in potentially explosive atmospheres as
defined by European Union Directive 94/9/EC and has been found to comply
with the Essential Health and Safety Requirements relating to the design and
construction of Category 3 equipment intended for use in Zone 2 potentially
explosive atmospheres, given in Annex II to this Directive.
Compliance with the Essential Health and Safety Requirements has been assured
by compliance with EN 60079-15 and EN 60079-0.
ATTENTION: This equipment is not resistant to sunlight or other sources of UV
radiation.
WARNING: This equipment shall be mounted in an ATEX-certified enclosure
with a minimum ingress protection rating of at least IP54 ( as defined in
IEC60529) and used in an environment of not more than Pollution Degree 2 (as
defined in IEC 60664-1) when applied in Zone 2 environments. The enclosure
must have a tool-removable cover or door.
WARNING: This equipment shall be used within its specified ratings defined by
Rockwell Automation.
WARNING: Should the unit be installed in an environment where induced
transients could exceed 44V, then external transient/surge arrestors should be
installed.
WARNING: Secure any external connections that mate to this equipment by
using screws, sliding latches, threaded connectors, or other means provided
with this product.
WARNING: Do not disconnect equipment unless power has been removed or
the area is known to be nonhazardous.
WARNING: Devices shall be used in an environment of not more than Pollution
Degree 2.