Rockwell Automation 1788-EN2PAR EtherNet/IP and ControlNet to PROFIBUS PA Linking Device User Manual - Manual (Page 22)

22 Rockwell Automation Publication 1788-UM058B-EN-P - September 2014
Chapter 1 Installation
Set the Linking Device
Network Address This section describes the network address switches.
Hardware Switches Location
The hardware switches are located under the front cover of the linking device.
Use the Page button to toggle between different diagnostics on the display.
Set the ControlNet Node Address
To set the ControlNet node address of the 1788-CN2PAR linking device, use the
hardware switches behind the front cover.