Rockwell Automation 1746-FIO4V SLC 500 Fast Analog I/O/ User Manual - Manual (Page 7)

7 Publication 1746-UM009B-EN-P - September 2007
Chapter
1
Quick Start
This chapter presents an overview of installation and start-up
procedures to help you get the module working quickly.
It refers to full procedures in corresponding chapters of this manual or
in other SLC documentation that may be helpful if you are unfamiliar
with programming techniques or system installation.
We recommend that you use this chapter in either of two ways.
• Use as a fast installation and start-up guide for the experienced
users.
• Use as an overview for using the entire manual for the first-time
user.
Required Tools and
Equipment Have the following tools and equipment ready.
• Medium flat-head screwdriver
• Medium Phillips-head screwdriver
• Wire strippers
• Utility knife
• Hot-air blower
• Shrink wrap
• Belden 8761 cable or equivalent
• Analog I/O devices for your application
• I/O modules (1746-FIO4I and/or 1746-FIO4V)
• Programming software
IMPORTANT
If you have any questions about the abbreviated procedures
presented in this chapter, always read the referenced chapters
and other recommended documentation before trying to apply
the information.