Rockwell Automation 1771-IFE ANALOG INPUT MODULE - Manual (Page 17)

2–5 Installing the Input Module
Publication 1771Ć6.5.115 - February 1999
The module is shipped with the series A/B simulation jumper set in
position
POS G for Series C applications. This setting returns input
data above and below the range end points. If you are replacing a
Series A or B 1771-IFE module with this module, and your
application cannot tolerate underrange/overrange data, reset the
simulation jumper to the
POS E position as shown below, to
internally limit input data to range end points.
POS G POS E
Simulation Jumper (shown in POS E position
for series A and B simulation)
Top edge of circuit board
1. Locatethesimulation jumper at thetop edge
of themodulecircuit board.
2. Using your fingers, slidethejumper off the2 posts.
3. Carefully position the jumper on 2 of the 3 posts that
correspond to your requirement.
Set the Series A/B Simulation Jumper
A/B
Simulation
Jumper
POS G POS E
Simulation Jumper (shown in POS G position
for series C )
Top edge of circuit board
Series A and B
Simulation
Series C
Application
Setting the Series A/B
Simulation Jumper