Rockwell Automation 1771-IFE ANALOG INPUT MODULE - Manual (Page 18)

2–6 Installing the Input Module
Publication 1771Ć6.5.115 - February 1999
Place your module in any slot in the chassis except the leftmost slot
which is reserved for processors or adapters.
!
ATTENTION: Observe the following precautions
when inserting or removing keys:
•
insert or remove keys with your fingers
•
make sure that key placement is correct
Incorrect keying or the use of a tool can result in
damage to the backplane connector and possible
system faults.
Upper Connector
11022ĆI
ATTENTION: Insert or remove
keying bands with your fingers.
I/O chassis
Keying Bands
Keying Band Location
Between10 and 12
Between 24 and 26
The 1771ĆIFE/C module is slotted at two places on the rear edge of the circuit board. These
slots mate with plastic keying bands which mount on the backplane connector.
Position the keying bands in the backplane connector to correspond to the key slots.
The keying bands can be repositioned if subsequent system design
and rewiring make insertion of a different type of module necessary.
Key the Backplane
Connector