Rockwell Automation 1771-IFE ANALOG INPUT MODULE - Manual (Page 26)

2–14 Installing the Input Module
Publication 1771Ć6.5.115 - February 1999
The front panel of the analog input module contains a green RUN
indicator and a red FAULT indicator. At power-up an initial module
self-check occurs. If there is no fault, the red indicator turns off.
RUN
FAULT
10528ĆI
ANALOG
IN
(12 BIT)
Green RUN indicator
Red FAULT indicator
The green indicator comes on when the module is powered. It will
flash until the module is programmed. If a fault is found initially or
occurs later, the red fault indicator lights. Possible module fault
causes and corrective action is discussed in Chapter 7,
Troubleshooting.
In this chapter you learned how to install your input module in an
existing programmable controller system and how to wire to the field
wiring arm.
Indicator Lights
Chapter Summary