Rockwell Automation 1734-XXXX POINT I/O and ArmorPOINT I/O DeviceLogix User Manual - Manual (Page 11)

9 Publication 1734-UM015A-EN-E - November 2009
Chapter
1
Introduction
About This Chapter This chapter introduces POINT I/O and ArmorPOINT I/O configurable
modules with DeviceLogix capability.
• About the Modules
• Quick Start - Prepare the Modules to work on DeviceNet
• Quick Start - Prepare the Modules to work on EtherNet/IP and
ControlNet
About the Modules The POINT I/O and ArmorPOINT I/O modules work with EtherNet/IP,
DeviceNet and ControlNet network adapters. Each module has eight 24V DC
I/O points that self-configure to be inputs or outputs. Inputs are IEC Type 3
and outputs are self-protecting 0.5 A outputs.
The firmware in these modules uses Version 3 of the DeviceLogix master
library. The modules can execute 144 DeviceLogix function blocks in 3 ms.
Smaller programs that contain fewer than 40 function blocks can be executed
in 1 ms.
Each module produces 20 bytes of data including I/O state (eight bits), eight
user-defined bits, and eight user-defined words of analog data to be consumed
by processors or other DeviceLogix modules. Each module consumes 20 bytes
of data to set the I/O state (eight bits), eight user-defined control bits, and
eight user-defined words of analog data. It is also possible to consume the data
from up to eight other peers.
This table lists 1734 and 1738 configurable I/O modules with DeviceLogix.
Module Description Cat. No.
POINT I/O module with 8 configurable 24V DC I/O points
and DeviceLogix capabilities 1734-8CFGDLX
ArmorPOINT I/O module with 8 configurable 24V DC M8
connectors and DeviceLogix 1738-8CFGDLXM8
ArmorPOINT I/O module with 8 configurable 24V DC M12
connectors and DeviceLogix 1738-8CFGDLXM12
ArmorPOINT I/O module with 1 configurable 24V DC M23
connector and DeviceLogix 1738-8CFGDLXM23