Chapter 6, About this chapter, Configure the module using the configuration tab – Rockwell Automation 1734-XXXX POINT I/O and ArmorPOINT I/O DeviceLogix User Manual User Manual
Page 51: Modules using rsnetworx for devicenet, Points. see, Chapter
Advertising
49
Publication 1734-UM015A-EN-E - November 2009
Chapter
6
Configuring POINT I/O and ArmorPOINT I/O
DeviceLogix modules using RSNetworx for
DeviceNet
About This Chapter
In this chapter, you will learn how to do the following:
•
Configure the module using the Configuration tab
•
Use the data on the Parameters tab
•
Configure peer communication
•
Produce data without using a master
•
Start the DeviceLogix Function Block Editor on the DeviceLogix tab
Configure the Module using
the Configuration tab
The following diagram shows the Configuration tab of a POINT I/O
DeviceLogix module in RSNetWorx for DeviceNet. The Configuration tab of
an ArmorPOINT I/O DeviceLogix module looks similar.
Advertising