Rockwell Automation 1734-XXXX POINT I/O and ArmorPOINT I/O DeviceLogix User Manual - Manual (Page 45)

43 Publication 1734-UM015A-EN-E - November 2009
Chapter
5
DeviceLogix for POINT I/O and ArmorPOINT
I/O on Ethernet/ControlNet
About This Chapter In this chapter, you will learn how to perform the following tasks:
• Create a POINT I/O DeviceLogix module in RSLogix 5000 when using
EtherNet/IP or ControlNet adapters
• Identify the tags created in your program for your use
• Use RSNetworx for DeviceNet to configure the POINT I/O
DeviceLogix module
Add a POINT I/O
DeviceLogix Module to
RSLogix 5000 To add a POINT I/O DeviceLogix module to RSLogix 5000, do the
following.
1. In the I/O Configuration tree, find the adapter.
In this example, we will be using the 1734-AENT with the
1734-8CFGDLX. The same procedure applies if you are using an
ArmorPOINT I/O DeviceLogix module, or if the network is
ControlNet.
2. Right-click the Point I/O Chassis and select New Module.