Rockwell Automation 1734-XXXX POINT I/O and ArmorPOINT I/O DeviceLogix User Manual - Manual (Page 32)

Publication 1734-UM015A-EN-E - November 2009
30 Install ArmorPOINT I/O DeviceLogix Modules
Remove the Module from the Mounting Base
Follow the instructions to remove the module from the mounting base.
1. Put a flat blade screwdriver into the slot of the orange latching
mechanism.
2. Push the screwdriver toward the I/O module to disengage the latch.
The module lifts up off the base.
3. Pull the module off the base.
Wire the Modules This section provides wiring instructions for the modules.
1738-8CFGDLXM8 I/O Module
ATTENTION
Make sure all connectors and caps are securely tightened to
properly seal the connections against leaks and maintain IP
enclosure type requirements.
MOD
NET
1738-8CFGDLXM8
24V DC
0 1
2 3
4 5
6 7
0
1
2
3
4
5
6
7
DLX
Connector M8-A
LED indicators
Connector M8-B
Connector M8-G
Connector M8-H
43683
Connector M8-C
Connector M8-E
Connector M8-F
Connector M8-D