Rockwell Automation 1756-xxxx ControlLogix Chassis and Power Supplies Installation Instructions - Manual (Page 28)

28 Rockwell Automation Publication 1756-IN005C-EN-P - March 2014
Chapter 1 Install Chassis and Power Supplies
Remove the Protective Label
Remove the plastic label from the top of the power supply.
Apply Power to the Chassis Turn on the power.
ATTENTION: Make sure the chassis is mounted and all panel fabrication is
complete before you remove the protective label. This label protects the power
supply from metal shavings falling inside the power supply and damaging it
during operation.
20264b-M
43615