Rockwell Automation 1756-xxxx ControlLogix Chassis and Power Supplies Installation Instructions - Manual (Page 52)

52 Rockwell Automation Publication 1756-IN005C-EN-P - March 2014
Chapter 2 Install Chassis and Redundant Power Supplies
Remove the Protective Label
Remove the plastic label from the top of the power supply.
Apply Power to the Chassis Turn on the power.
ATTENTION: Make sure the power supply is mounted and all panel fabrication
is complete before you remove the protective label. This label protects the
power supply from metal shavings falling inside the power supply and
damaging it during operation.
42841
43615