Rockwell Automation 2755 2D Hand-Held Scanner - Manual (Page 135)

Flexible Interface Module Application C–3
Publication 2755-6.7
Configuration Codes for Flexible Interface Module Application
1. After making the necessary connections, scan the following
following bar code symbol to set the scanner to its default
settings.
Set Scanner Defaults
2. Set the RS-232 Synapse cable to defaults by scanning the
following:
Set RS-232 Synapse Cable Defaults
3. The cable defaults will work with the Flexible Interface Module.
Your application may have specific requirements. Chapter 3 lists
the settings that can be modified. If you change a communication
setting, make sure the Flexible Interface Module is configured to
accept the change.