Rockwell Automation 2755 2D Hand-Held Scanner - Manual (Page 147)

E–2 PLC-5 Controller Application
Publication 2755-6.7
Hardware Connections
The scanner connects to the Channel 0 port of the PLC with an
RS-232 Synapse cable (Catalog No. 2755-HFC-SR2-01). The
connections are shown in the scanner user manual (Publication
2755-6.2).
To Channel 0 Port
Power Supply
Scanner Cable
RS-232 Synapse Cable
(2755-HFC-SR2-01)
Scanner
PLC-5
Note: The power supply
should be connected last.
Scanner Configuration
Configure the scanner using the bar codes described in Chapter 1.
The PLC controller does not require any specific scanner
configuration. However, you will need to configure the cable
communication parameters as described on the next page.