Rockwell Automation 2755 2D Hand-Held Scanner - Manual (Page 146)

Appendix
E
Publication 2755-6.7
PLC-5 Controller Application
This appendix describes how to configure and operate the scanner
when connected to a PLC-5 controller.
!
ATTENTION: Do not install the RS-232 Synapse
cable with power applied to either the Synapse cable or
PLC controller. Failure to follow this caution may
result in damage to the scanner, Synapse cable, or PLC.
For additional reference you should refer to the following
publications:
•
PLC-5 User Manual
•
6200 Series Programming Software User Manual