Rockwell Automation 2755 2D Hand-Held Scanner - Manual (Page 33)

2–2 RS-232 Synapse Cable
Publication 2755-6.7
Set RS-232 Synapse Cable Defaults
Scan this label to set the default settings for the RS-232 Synapse
cable. Defaults are indicated with an asterisk.
Set RS-232 Synapse Cable Defaults
Scan this label to set the RS-232 Synapse cable to the default settings
shown below.
RS-232 Synapse Cable Parameters Default Setting
Code on
Page:
Host Standard RS-232 2–3
Baud Rate 9600 2–4
Parity None 2–5
Check Parity Enabled 2–5
Stop Bits 1 2–6
Data Bits 8 2–6
RTS State Low 2–7
Hardware Handshaking None 2–7
Software Handshaking None 2–8
Beep on BEL Disabled 2–9
Unknown Characters
Send Bar Codes With Unknown
Characters
2–9
Response Timeout 2 Seconds 2–10
Parameter Set Set #1 2–12
Scan the bar code symbols for the settings you need to change.