Rockwell Automation 2755 2D Hand-Held Scanner - Manual (Page 157)

DTAM t Plus DeviceNet t Application F–5
Publication 2755-6.7
DTAM Plus Operator Interface Setup
You may need to configure the DTAM Plus Operator Interface
RS-232 port to accept the scanner data. Refer to the DTAM
Programming Software Programming Manual. Configure the
DTAM Plus Operator Interface serial port as shown below.
1. Open Screen Builder.
2. Open Create Screen.
3. Open Data Entry Screen.
4. Select Set Up Screen.
5. Select Data Entry.
6. Select ASCII Input.
7. Set up DTAM.