Rockwell Automation 7000 PowerFlex Medium Voltage AC Drive (B Frame) - ForGe Control (PanelView 550) - Manual (Page 215)

Rockwell Automation Publication 7000-UM151E-EN-P - January 2013 215
Drive Programming and Parameters Chapter 5
Numerical Value
Selecting a parameter with a numerical value prompts the MODIFY
PARAMETER screen, as in this example:
Figure 192 - Parameter data entry—numeric value
This screen shows:
• the parameter name (i.e. Rated motor volt)
• the parameter tag code (i.e. 22)
• the parameter’s configurable minimum and maximum limits (i.e. 4000 to
4160)
• the parameter data unit
• the current configured parameter value
Figure 193 - Modify Numerical Value
Use the data entry keys [0]-[9] to enter the new value. Type [-] to enter a negative
value. Use [.] to enter a decimal point for fractional values. Edit the value by
pressing [Backspace]. Press [Enter] to accept the new value as shown in
Figure 193 . If the new value is outside the defined limits, the interface will not
accept the new value. For example: If you type 900 when the minimum value is
4000, the value does not change.