Rockwell Automation 7000 PowerFlex Medium Voltage AC Drive (B Frame) - ForGe Control (PanelView 550) - Manual (Page 218)

218 Rockwell Automation Publication 7000-UM151E-EN-P - January 2013
Chapter 5 Drive Programming and Parameters
Bit-Encoded Value
When you select a bit-encoded parameter, the interface displays the following
screen:
Figure 198 - Modify Bit Encoded Value
This screen shows:
• the name of the selected parameter(i.e. Logic Mask)
• the parameter tag code (i.e. 241)
• the selected bit (Adapter 0)
• the current value of the parameter bits.
On this screen, use
◄
or
►
to select bits within the parameter. The interface
displays the name of each selected bit. Use
▲
or
▼
to toggle the bit state.
IMPORTANT To edit ANY parameter, you must have an access level above 'Monitor'.
Press [F8] and enter the appropriate PIN to access and modify drive
parameters. Refer to
Configuring Access Levels on page 210 for more
information on access security.
IMPORTANT The interface does not implement new values until you press [F10] to exit
the screen. Prior to this you can modify the new value by repeating the
above procedure, or cancel by pressing [F7]. Cancelling returns the option
to the original value.