Rockwell Automation 6180W-xxxx VersaView Workstation User Manual - Manual (Page 22)

Publication 6180W-UM001H-EN-P - August 2007
22 Installation
Mount the Display Workstation in a Panel
Mounting clips secure the workstation to the panel. The 1200W
requires 10 clips; the 1500W requires 12 clips.
1. Remove electrical power from the panel.
2. Cut an opening in the panel using the appropriate panel cutout
dimensions.
3. Make sure the sealing gasket is properly positioned on the
computer.
This gasket forms a compression-type seal. Do not use sealing
compounds.
4. Place the computer in the panel cutout.
5. Slide the mounting clips into the slots on the top, bottom, and
sides of the computer.
ATTENTION
Remove all electrical power from the panel before making
cutout.
Make sure the area around the panel cutout is clear.
Take precautions so metal cuttings do not enter components
already installed in panel.
Failure to follow these warnings may result in personal injury or
damage to the panel components.