Rockwell Automation 6180W-xxxx VersaView Workstation User Manual - Manual (Page 44)

Publication 6180W-UM001H-EN-P - August 2007
44 Replace System Components
Remove the Floppy Drive
This procedure shows how to remove the floppy drive from the
1500W and non-display workstations.
1. Disconnect power from the computer.
2. Remove the back cover.
3. Disconnect the flat cable and the four-pin power cable at the
floppy drive.
4. Remove the two M3 screws from each side of the floppy drive
on the outside of the chassis.
5. Slide the drive cage toward the power supply to access both
sides of the floppy drive to disengage lock points.
6. Remove the six screws that secure the floppy drive to the drive
cage.
7. Slide the floppy drive out the front of the cage.
TIP
For the 1200W, remove the drive assembly as described under
Replace the Hard Disk Drive. You can then remove the floppy
drive similar to the 1500W and non-display workstations.
IMPORTANT
Note the location and orientation of all cables before you
remove the existing power supply and cabling, so that you can
reattach them correctly.
Drive Cage
Lock Point