Rockwell Automation 6180W-xxxx VersaView Workstation User Manual - Manual (Page 46)

Publication 6180W-UM001H-EN-P - August 2007
46 Replace System Components
Replace the
CD-ROM/DVD-ROM Drive Follow these precautions when working with the CD-ROM/DVD-ROM
drive.
•
Do not touch internal components.
•
Always handle the drive by its metal frame.
•
Store the drive in an anti-static bag when it is not installed.
•
Never disconnect or install a drive with the power on.
Remove the Drive
The procedure shows how to remove the CD/DVD drive from the
1500W and non-display workstations.
1. Disconnect power from the computer.
2. Remove the back cover.
3. Disconnect the power supply, audio cable, and ribbon cable
from the drive.
ATTENTION
Failure to follow proper safety precautions could result in
severe electrical shock and/or damage to the computer.
ATTENTION
Mechanical shock can damage a CD-ROM or DVD-ROM drive.
Do not drop or bump the drive.
TIP
For the 1200W, remove the drive assembly as described under
Replace the Hard Disk Drive. You can then remove the CD/DVD
drive similar to the 1500W and non-display workstations.
IMPORTANT
Note the location and orientation of all cables before you
remove the existing power supply and cabling, so that you can
reattach them correctly.