Rockwell Automation 6180W-xxxx VersaView Workstation User Manual - Manual (Page 39)

Publication 6180W-UM001H-EN-P - August 2007
Replace System Components 39
9. For lower profile cards, loosely attach a padded hold down
finger to the hold down bracket.
10. Reattach the hold down brackets to the chassis with the screws
removed earlier.
11. Position and tighten the hold down finger, if appropriate.
12. Reinstall the cover.
Remove an Add-in Card
Follow these steps to remove an add-in card.
1. Disconnect power from the computer.
2. Remove the cover.
3. Remove the hold down bracket by removing the screw securing
it to the chassis.
4. Lift the hold down bracket out of the bracket latch at the other
end.
5. Remove the screw securing the add-in card’s orb to the chassis.
6. Pull the add-in card free of the slot.
Store the card in an anti-static wrapper.
7. Install a slot cover over the open slot and secure with the screw
you removed earlier.
Add-in card
Hold Down Finger