Rockwell Automation 6180W-xxxx VersaView Workstation User Manual - Manual (Page 37)

Publication 6180W-UM001H-EN-P - August 2007
Replace System Components 37
Remove the Back Cover on the 1500W
Follow these steps to remove the back cover of the 1500W
workstation.
1. Disconnect power from the computer.
2. Loosen the two thumb screws securing the back cover.
3. Lift the cover up to disengage from the base.
4. To reinstall the back cover, position the back cover over the
chassis, sliding the cover down to engage the brackets at the
base and tighten the thumb screws.
Install or Remove Add-in
Cards You can install ISA and PCI compatible cards.
ATTENTION
Failure to follow proper safety precautions could result in
severe electrical shock and/or damage to the computer.
ATTENTION
Add-in cards are sensitive to ESD and require careful handling.
Hold cards only by the edges. Do not touch connectors,
components, or circuits. After removing a card, place it on a
flat, static-free surface, component side up. Do not slide the
card over any surface.