Rockwell Automation 4100 REC Resolver to Encoder Converter Installation and Setup Manual - Manual (Page 6)

Publication 999-126 - February 1996
Preface
Preface
Read This Manual Read and understand this instruction manual. It provides the
necessary information to let you install, connect, and set up the AEC
for safe, reliable operation. This preface covers the following topics:
• Who should use this manual
• The purpose of this manual
• Terms
• Common techniques used in this manual
• Allen-Bradley support
Who Should Use this Manual You should read this manual if you are responsible for the installation,
set up or operation of the AEC (Absolute Encoder Converter).
If you do not have a basic understanding of the products listed below,
contact your local Allen-Bradley representative for information on
available training courses before using this product.
• S Class Compact motion controller
• 1394 GMC System module
• GML (Graphic Motion Language) Commander software
Purpose of this Manual This manual is an installation and set up guide for the REC (resolver
to encoder converter) and describes the procedures necessary to
properly install and configure it into your motion control system.