Rockwell Automation 4100 REC Resolver to Encoder Converter Installation and Setup Manual - Manual (Page 7)

Publication 999-126 - February 1996
2 Preface
Safety Precautions The following general precautions apply to the AEC:
!
ATTENTION: Electric shock can kill. Make sure the
AEC is safely installed in accordance with the Installation
and Set-up chapters of this manual. Avoid contact with
electrical wires and cabling while power is on. Only
trained service personnel should open the electrical
cabinet.
ATTENTION: This product contains stored energy
devices. To avoid hazard of electrical shock, verify that
all voltage on the capacitors has been discharged before
attempting to service, repair, or remove this unit. You
should only attempt the procedures in this manual if you
are qualified to do so and familiar with solid-state control
equipment and the safety procedures in publication NFPA
70E and BS-EN60204.
ATTENTION: The system integrator is responsible for
local safety and electrical codes.
!
ATTENTION: An incorrectly applied or installed
product can result in component damage or a reduction
in product life. Wiring or application errors, such as
undersizing or inadequate DC supply, or excessive
ambient temperatures can result in a malfunction.
ATTENTION: The AEC contains ESD (Electrostatic
Discharge) sensitive parts and assemblies. Static control
precautions are required when installing, testing,
servicing, or repairing this assembly. Component damage
can result if ESD control procedures are not followed. If
you are not familiar with static control procedures, refer
to Allen-Bradley publication 8000-4.5.2, Guarding
Against Electrostatic Damage or any other applicable
ESD Protection Handbook.