Rockwell Automation 2711 PanelBuilder 1200 Transfer Utility - Manual (Page 10)

Chapter
2
2-1
Setting Up the PanelView 1200 Transfer Utility
This chapter provides instructions for setting up and using the PanelView
1200 Transfer Utility. It tells you about the following:
the minimum hardware and software requirements you need to be able
to run the PanelView 1200 Transfer Utility
installing the PanelView 1200 Transfer Utility
starting the PanelView 1200 Transfer Utility
working with the PanelView 1200 Transfer Utility
exiting from the PanelView 1200 Transfer Utility
To install the PanelView 1200 Transfer Utility you must have the following
equipment:
Personal Computer
Your personal computer requirements depend on how you install the
PanelView 1200 Transfer Utility. You can install this software in two ways:
From the PanelBuilder 1400e Configuration Software for Windows
installation CD. To be able to do this, you must have Microsoft
Windows installed on your computer.
Directly from the PanelBuilder 1400e Transfer Utilities CD.
For both methods, you must have a personal computer (PC

) with the
following features:
Hard disk (recommended)
CD Drive
RS-232 serial port
The following table lists how the requirements differ, depending on the
method you choose.
System Requirements