Rockwell Automation 2711 PanelBuilder 1200 Transfer Utility - Manual (Page 35)

Transferring Via the Data Highway Plus
Chapter 4
and Remote I/O
4-9
Programming Terminal Configuration Parameters
Before you can transfer an application file, you must configure your
computer so it can communicate with the Data Highway Plus. You must
define the address of the computer on the network and the type of
hardware driver you’re using.
You must define these parameters:
Programming Terminal DH+ Address—Defines the Data Highway
Plus address of the PC you will be using to download application files.
DH+ Hardware Driver—You can choose from:
1770-KF2/1785-KE—Choose a port, baud rate, parity, half/full
duplex, and error-checking type.
1784-KL—Choose between multi-drop or direct connection types.
1784-KT—Choose between multi-drop or direct connection types,
and enter the driver card location. See the following section for more
information about this driver, and Appendix A, Troubleshooting, for
driver card memory location data.
Note Choose the 1784-KT driver if you want to use the 1784-PCMK
card. See the following section for information on installing PCMK
drivers.
1784-KT2—Choose a connection type and a Driver Card Location.
1784-KTK1—Choose a connection type, a Driver Card Location, and
an interrupt number.
Pass-Through Utility Directory—This field identifies the directory of the
Pass-Through utility files.
Note If you installed the Pass-Through Utility in a location different
from that of the default installation, you’ll have to change the directory
when you first run the PanelView 1200 Transfer Utility.