Rockwell Automation 2711 PanelBuilder 1200 Transfer Utility - Manual (Page 48)

Transferring Application Files with
Chapter 5
User PROMs
5-5
To burn a single EPROM for Series D, E and F terminals:
1 Connect your computer to an EPROM burner with an RS-232 serial
cable.
The EPROM burner is connected to the same RS-232 port on the
development computer that is used to connect the PanelView 1200
terminal. Refer to your EPROM burner user’s manual for connection
instructions.
2 Start the PanelView 1200 Transfer Utility.
3 Open the Transfer menu.
4 Choose Burn Single EPROM from the Transfer menu.
5 Choose Select Application File and select the application you want to
download to the EPROM burner. Press
ENTER .
If the file is greater than 64K, a warning message appears: “This
application exceeds the memory limit (64K) for hex files or PROMs.
Delete one or more objects, messages, or screens to reduce size to 64K
or less”.
PanelBuilder takes a few seconds to generate the hex file. When the file
is created, a message appears, informing you that the hex files have been
generated successfully. The Burn FILENAME menu opens, (where
FILENAME is the name of the application you selected).
23625
MAIN MENU: Screens Windows Options Communic Exit Transfer
Download to PanelView (RS-232)
Upload from PanelView (RS-232)
Pass-Through Download to PanelView (DH+ and Remote I/O)
Pass-Through Upload from PanelView (DH+ and Remote I/O)
Burn EPROMS
Burn Single EPROM
Quit
Burn Single EPROM
Select Application File EXAMPLE
Select Hex File EXAMPLE
Generate Hex Files EXAMPLE
Directory
Quit
Burn EXAMPLE
Send User Memory [U2]
Configure Port COM1
Application Size
Quit