Rockwell Automation 2711 PanelBuilder 1200 Transfer Utility - Manual (Page 33)

Transferring Via the Data Highway Plus
Chapter 4
and Remote I/O
4-7
Configuring the PanelView Location Data
Before you can initiate the download you must define the following
PanelView location data:
PLC DH+ Address—This address defines the address of the PLC
controller on the Data Highway Plus.
Local Bridge Address—Define this field only if you have two Data
Highway Plus networks joined by a connecting module or “bridge”.
Remote Bridge Address—Define this field only if you have two Data
Highway Plus networks joined by a connecting module or “bridge”.
To establish the PanelView location data:
1 Choose Pass-Through Download to PanelView (DH+ and Remote I/O)
in the Transfer menu.
Note Don’t exit this menu when you’re finished making changes.
23639
IN MENU Develop Transfer Reports FilesCopy File Exit Transfer
Download to PanelView (RS-232)
Upload from PanelView (RS-232)
Pass-Through Download to PanelView (DH+ and Remote I/O)
Pass-Through Upload from PanelView (DH+ and Remote I/O)
Burn EPROMs
Burn Single EPROM
Quit
The Pass-Through Download to PanelView menu appears.