Installing connected components workbench software, Powering up the converter – Rockwell Automation 1203-USB Converter User Manual
Page 30
2-12
Installing the Converter
PowerFlex 1203-USB Converter User Manual
Publication DRIVES-UM001D-EN-P
21. Verify that the drivers have been correctly installed by expanding Ports
(COM & LPT) in the Device Manager treeview as shown below.
‘Allen-Bradley 1203-USB (COMx)’ should appear in the treeview. Note
the COM port being used. This COM port number will be used later to
configure a driver using RSLinx software to represent the connection on
the COM port. This is required for either the Connected Components
Workbench or DriveExecutive software tool. See
Components Workbench Software on page 3-2
or, for DriveExecutive
software,
Configuring the Converter on page D-2
for details.
Installing Connected
Components Workbench
Software
If you do not have Connected Components Workbench software on your
computer and intend to use it as your configuration tool, you can obtain a
free copy. See
User-Supplied Equipment on page 1-5
for details. Follow the
instructions included with the software.
Powering Up the Converter
The 1203-USB converter receives power from the drive, so the drive must
be powered before the converter will operate. The Diamond status indicator
on the converter flashes green to indicate that the converter is properly
installed and receiving power. If it is not green, see
.