Rockwell Automation 1203-USB Converter User Manual
Page 46
3-14
Configuring the Converter
PowerFlex 1203-USB Converter User Manual
Publication DRIVES-UM001D-EN-P
11. On the Advance Browse Settings tab, check ‘Force network type to’.
12. From the pull-down menu, choose DF1 (master or slave).
13. Click OK.
14. Close RSLinx software.
Accessing Drives on the RTU Master (Serial Multi-drop) Network
Connected Components Workbench software enables you to monitor,
configure, and control any of the drives on the RTU Master (serial multi-drop)
network. You can also monitor and configure the 1203-USB converter.
1. In the Device Toolbox right pane, select Discover and click Browse
Connections to open the Connection Browser.
The serial driver should show all of the drives that are powered up on
the serial network. The image below shows five DSI drives on the
multi-drop network.
If you do not see all of your drives on the network:
– Make sure the drives are powered up.
– Verify the COM port to which the 1203-USB converter is assigned.