Rockwell Automation 1203-USB Converter - Manual (Page 34)

3-2 Configuring the Converter
PowerFlex 1203-USB Converter User Manual
Publication DRIVES-UM001D-EN-P
Using Connected
Components Workbench
Software
With Connected Components Workbench software, version 1.02 or later,
you can edit parameters in both the 1203-USB converter and the connected
drive. With DPI and DSI drives, you can also edit parameters in any of their
connected peripherals.
Important: For Connected Components Workbench software to operate
with DSI drives point-to-point, converter Parameter 01 -
[Adapter Cfg] must be set to ‘0’ (Auto, the default). If this
parameter needs to be changed, HyperTerminal software can be
used to configure the converter (see
Use with HyperTerminal
Software on page E-1 ).
This procedure is provided to help you use Connected Components
Workbench software with the 1203-USB converter. If you are unsure how to
complete a step, refer to the software online help (from the Help menu,
choose Help Topics).
1. Obtain and note the COM port that was assigned during installation of
the 1203-USB driver (on page 2-8 ) by doing the following.
When Using Windows XP Operating System
a. Open the Windows Control Panel and double-click System.
b. In the System Properties window, click the Hardware tab.
c. Click Device Manager.
When Using Windows 7 Operating System
a. Open the Windows Control Panel.
b. Click Device Manager.
2. In the Device Manager treeview, expand the Ports (COM & LPT) group.
The assigned COM port is shown in parenthesis at the end of the
Allen-Bradley 1203-USB entry.