Banner SureCross DX80 Wireless Networks - Manual (Page 21)

changes to the Ethernet Bridge or GatewayPro,
all changes are lost.
Get Click the Get button to read all device and I/O
parameters from the DX80 device and load them
into the Web Configurator screens. This does not
save the parameters to the XML file.
Refresh Click the Refresh button to refresh the screen
image. This updates any information on the
screen that may have changed on the device.
Send Clicking the Send button transmits device and I/O
parameters to the radio devices. The Send opera-
tion usually requires several second to complete.
DX80 Modes
Setting Gateway GatewayPro Ethernet
Bridge
DX80 is Modbus/
TCP Client/Server
(default) Slave Master Master Default mode. The Gateway is a Modbus slave device and the Ether-
net Bridge is the master device.
DX80 is Modbus
RTU Master Master Master Ignored The Ethernet Bridge can only communicate with a slave device. In
this mode, any communications sent to the Bridge from the Web
Configurator is ignored. To resume communications, cycle power to
the Gateway. When power is cycled, the Ethernet Bridge begins
again as a master device until the timeout lapses.
DX80 is Modbus
RTU Slave Slave Slave Ignored Similar to the default mode, but a device other than the Ethernet
Bridge acts as the Modbus master device. The Ethernet Bridge still
communicates with the Gateway and can read and write to registers,
but another device is the master device.
DX80 is a Modbus/TCP Client/Server (default)
The default configuration is DX80 is Modbus/TCP Client/Server. The DX83 Ethernet Bridge is the Modbus master device and only
communicates with the device configured as Slave ID 1: the Gateway.
SureCross Web Configurator
rev. - www.bannerengineering.com - tel: 763-544-3164 21