Banner SureCross DX80 Wireless Networks - Manual (Page 61)

The expected acknowledgement code is included in the outgoing notification e-mail. A typical notification code may look like !
08052012R1! and must be included in the reply in exactly the same form, including the exclamation points. Replying and sending the e-
mail from within the e-mail program is sufficient as long as the e-mail reply includes the original message.
Repeat Time. The Repeat Time is the rate at which the e-mail is repeated and is given as D,HH:MM for days,hours:minutes. There
should be no embedded spaces between days and hours, only a comma. If set to zero, and a single 0 will suffice, repeating is disabled.
E-mails are only repeated for Notify on True. Notify on False messages are not repeated unless the threshold rule goes true, then false
again.
System Start-Up. Notification on System Start-Up is a pre-defined event and only repeats if Expect Ack is checked. If unacknowledged,
it will not be repeated and the repeat time is disregarded.
Prev and
Next Use the Prev and Next buttons to scroll
through the list of events if the events list re-
quires more than one page. Up-
date Clicking the Update button sends information to the
Ethernet Bridge or GatewayPro or retrieves infor-
mation depending on which checkboxes are selec-
ted: Change or Get/Send All. Updating information
does not save configuration information perma-
nently to the XML file.
E-mail Server
Before the DX80 devices can send e-mail, the e-mail server and account information must be entered in the E-mail Server page.
The information entered on this page represents the e-mail’s origin, not destination. The User Name refers to the account login name
assigned to this Ethernet Bridge or GatewayPro device. The System Contact must be the e-mail name assigned to the account (for
example, [email protected]).
When using a DNS server on the Network tab, use Domain Names as shown in the example below. Otherwise, enter the IP addresses of
the SMTP and POP3 servers. Click the Update button on that section of the screen. Fill in the System Name, System Location, and
System Contact information. The System Contact MUST be the e-mail account name. Click the Update button on the lower section of the
screen to submit the changes.
SMTP IP Address. The SMTP IP address is used if the SMTP server (outgoing e-mail) is at a static IP address. If the SMTP server is
known only by domain name and its IP address may change, use the domain name and verify the Network tab uses a DNS server. Set
SureCross Web Configurator
rev. - www.bannerengineering.com - tel: 763-544-3164 61