Banner SureCross DX80 Wireless Networks - Manual (Page 78)

E-mail Error Codes
E-mail error codes are listed in the following tables.
The missing recipient error should not occur because no send is attempted when no recipient is defined. The most likely error is a server
error, referring to an error with the connection to the e-mail server. Check the SMTP address, e-mail login, and password.
E-mail error codes are positive or negative numbers depending on when the error occurs. If the error occurs in the e-mail client after the
data logger creates the message, it is a negative code. If the message never got to the e-mail client, the error code is positive.
Positive Error Codes
Positive error codes are detected prior to the attempt to send the e-mail. These are detected primarily in preparation to send.
Other than a missing recipient address, the most common error code is (+15) NoDNSaddress. This error indicates the system could not
find the mail server’s IP address using DNS host lookup. The nameserver might not be accessible or the host name is incorrect.
• 0: eSendMail_Success
• 1: eSendMail_NoAccessLogin
• 2: eSendMail_ServerBusy
• 3: eSendMail_ServerNotReady
• 4: eSendMail_MissingRecipient
• 5: eSendMail_MissingSender
• 6: eSendMail_ServerError
• 7: eSendMail_ErrorRecipient
• 8: eSendMail_TooManyRecipients
• 9: eSendMail_ErrorCc
• 10: eSendMail_TooManyCc
• 11: eSendMail_ErrorAttachment
• 12: eSendMail_TooManyAttachment
• 13: eSendMail_ErrorSend
• 14: eSendMail_BodyFull
• 15: eSendMail_NoDNSaddress
Negative Error Codes
Negative error codes are detected after the send process has begun. The most common error code, (-13), has the least useful name
(General Error). However, it often means the login name and/or password were not accepted by the mail server or they do not match the
sender’s e-mail address. In general, it means the DX80 was unable to log into the mail server for any of a variety of possible reasons
related to an invalid login or broken connection.
Error code (-9) occurs when there is an attempt to send an e-mail before the previous e-mail has completed the send process. Error code
(-15) indicates the data log file that the DX80 was attempting to attach to an e-mail could not be accessed.
• 0: NAMAILC_OK
• -1: NAMAILC_MISSADDRESS
• -2: NAMAILC_INVALIDBODY
• -4: NAMAILC_NOSERVER
• -5: NAMAILC_NOMAILBOX
• -6: NAMAILC_TCPERROR
• -7: NAMAILC_CANCELLED
• -8: NAMAILC_SYNTAXERROR
• -9: NAMAILC_MAILBOXBUSY
• -13: NAMAILC_GENERALERROR
• -14: NAMAILC_BUFFERFULL
• -15: NAMAILC_FILESYSTEMERROR
• -16: NAMAILC_INVALIDFILE
SureCross Web Configurator
78 www.bannerengineering.com - tel: 763-544-3164 rev. -