Banner SureCross DX80 Wireless Networks - Manual (Page 26)

Showing Lists the pages of registers for the selected
slave (RTU unit). configuration information permanently to the
XML file.
Update
checkbox Unless the Update checkbox is selected, this
register data will not be submitted to the
Ethernet Bridge or GatewayPro.
RTU Error Codes
The first occurrence of read and write errors are shown along with the map number that was processing when the error occurred.
Select the Reset checkbox to the left of the error codes and click the Update button to clear the error. If more than one error is active, the
next error code displays.
The right four columns display a count of errors for all maps for each device. Select the Reset checkbox left of the Total Messages
column and click Update to reset the counts. Click Update to view the most recent values.
RTU and TCP Error Codes (A/B Format)
Error codes (A/B format) indicate the following errors with the first number:
1. n/a for RTU (Transaction ID out of sync)
2. Exception code returned by remote device
3. Function code mismatch (bad packet)
4. Insufficient data (bad packet)
5. No response from remote device, timed out
6. CRC error in received packet
When A is code 2, indicating an exception code was returned, B indicates the exception as follows:
1. Illegal function code
2. Illegal data address (the requested register does not exist in the device)
3. Illegal data value
SureCross Web Configurator
26 www.bannerengineering.com - tel: 763-544-3164 rev. -