Banner SureCross DX80 Wireless Networks - Manual (Page 44)

Enter the single destination register or a range of destination registers to copy the source register to. If no last destination register is
entered, only a single destination register is used.
Do not use the same source register more than once in the cascade rules. To copy a register’s contents to multiple, non-consecutive
registers, only use the primary source register once. To copy the same contents to additional registers, use the previous destination
register as the second rule’s source register and ‘daisy-chain’ the register contents. For example, do not create three rules to copy regis-
ter 5’s contents to register 6, 14, and 18. Instead, create one rule to copy register 5’s contents to register 6, a second rule to copy register
6’s contents to register 14, and a third rule to copy register 14’s contents to register 18.
Entering a zero as a source register negates the rule even though it remains in the list until deleted. Unused rules at the end of the list
always show zero as the source register. To prevent these from displaying, reduce the number of rules enabled.
Delete
and In-
sert Clicking the Delete button removes the rule or
map number shown in the Rule # or Map # box.
Clicking the Insert button inserts a new map
ahead of the map number shown. It is not neces-
sary to use the Insert button to add maps to the
bottom of the list or to define any rule with None
as the register type. To add a map/rule to the bot-
tom of the list, increase the number of rules or
maps enabled.
Prev
and
Next If there are more than 16 devices or rules/maps,
use the Prev and Next buttons to display the next
screen of information.
Up-
date Clicking the Update button sends information to the
Ethernet Bridge or GatewayPro or retrieves infor-
mation depending on which checkboxes are selec-
ted: Change or Get/Send All. Updating information
does not save configuration information perma-
nently to the XML file.
Calculate
Use the Calculate tab to set up simple calculations on the register data.
Entering none as the operation negates the rule even though it remains in the list until deleted. Unused rules at the end of the list always
show none as the operation. To prevent these from displaying, reduce the number of rules enabled.
SureCross Web Configurator
44 www.bannerengineering.com - tel: 763-544-3164 rev. -