Banner SureCross DX80 Wireless Networks - Manual (Page 67)

The Device # field shows which device is displayed. Use the Prev and Next buttons to scroll through the devices.
In the sample screens shown, device 0, I/O point 1 (Gateway Discrete IN 1) is mapped to device 1, I/O point 9 (Node Discrete OUT 1).
Each of device 0’s input points 1, 2, 5, and 6 are mapped to the corresponding outputs on device 1. Similarly, device 1’s inputs 1, 2, 5,
and 6 are mapped to device 0’s outputs 9, 10, 13, and 14.
Banner Engineering does not recommend linking multiple inputs to a single output on any SureCross device. The result will not be “Logic
OR” of the multiple inputs; rather, the output will respond to any input state changes as they occur. This will result in unpredictable and/or
undesirable network behavior.
After making changes to any screen, click the Change button to submit these changes to the Ethernet Bridge then click the Send button
to submit the I/O linking changes to the DX80 radio devices. If you make changes to a page and leave the page without submitting those
changes to the Ethernet Bridge, the changes are lost.
To save the changes to the XML file, go to the System > Setup > Config File page and click the Save button. Changes made by clicking
an Update or Change button are temporary until the changes are saved permanently in the configuration file.
Link Timeouts
The Link Timeout parameters control how the wireless network devices behave during an RF communications failure.
SureCross Web Configurator
rev. - www.bannerengineering.com - tel: 763-544-3164 67